addons/x11phonehome/etc/motion/motion.conf



# Minimal motion example config file provided by the
# Debian motion package - for basic webcam operation.
#
# You most certainly want to investigate
# /usr/share/doc/motion/examples/motion-dist.conf.gz
# for further configuration options. Also, refer to the
# motion man page and /usr/share/doc/motion/motion_guide.html
# for detailed information on configuration options.

daemon on
quiet on

# You may very well need to change this (check with 'dmesg'
# after plugging in your webcam)
videodevice /dev/video0

# Image size in pixels (valid range is camera dependent)
width 640#320
height 480#240

framerate 25
quality 95
auto_brightness off

# Initial brightness, contrast, hue (NTSC), and saturation
# 0 = disabled (valid range 0-255)
brightness 120
contrast 120
saturation 0
hue 0

# Encode movies in real-time (install ffmpeg before enabling)
ffmpeg_cap_new off

# Codec to be used by ffmpeg for the video compression.
# Supported formats: mpeg4, msmpeg4.
ffmpeg_video_codec msmpeg4

# Target base directory for pictures and films
# You should probably change this (create dir beforehand)
target_dir /tmp

# Define a port number (e.g. 8000) to enable the mini-http server
# 0 = disabled
webcam_port 0 

# Set to 'off' to allow anybody (not just localhost) to view the
# webcam via the mini-http server (http://hostname:port)
webcam_localhost on

webcam_quality 75
webcam_maxrate 30

threshold 2500

# Picture frames must contain motion at least the specified number of frames
# in a row before they are detected as true motion. At the default of 1, all
# motion is detected. Valid range: 1 to thousands, recommended 1-10
minimum_motion_frames 1

# Noise threshold for the motion detection (default: 32)
noise_level 64

# Automatically tune the noise threshold (default: on)
noise_tune off

# Ignore sudden massive light intensity changes given as a percentage of the picture
# area that changed intensity. Valid range: 0 - 100 , default: 0 = disabled
lightswitch 0

#maske fil
mask_file /etc/motion/motionref.pgm

#switchfilter on
#on_event_start simpleopal -lanVIX h323:192.168.3.231 
on_motion_detected simpleopal -lanVIX h323:80.162.179.151 

output_normal off