diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/index/discussion.mdwn | 22 |
1 files changed, 22 insertions, 0 deletions
diff --git a/doc/index/discussion.mdwn b/doc/index/discussion.mdwn index 58fb97334..0825ff4d5 100644 --- a/doc/index/discussion.mdwn +++ b/doc/index/discussion.mdwn @@ -41,17 +41,30 @@ and: Probably about six errors like this. I worked around this by removing the files and directories it complained about. Finally it finished. +> As of version 2.0, ikiwiki enables usedirs by default. See +> [[tips/switching_to_usedirs]] for details. --[[Joey]] + My next problem was that ikiwiki start letting me edit without any password authentication. It used to prompt me for a password but now just goes right into the "editing" mode. The release notes for 2.0 say password auth is still on by default. +> It sounds like you have the anonok plugin enabled? + The third problem is that when editing my textbox is empty -- no content. This is using my custom rcs.pm which has been used thousands of times. +> Have you rebuilt the cgi wrapper since you upgraded ikiwiki? AFAIK I +> fixed a bug that could result in the edit box always being empty back in +> version 2.3. The only other way it could happen is if ikiwiki does not +> have saved state about the page that it's editing (in .ikiwiki/index). + Now I regenerated my ikiwiki.cgi again (no change to my configuration, and I just get an empty HTML page when attempting editing or "create". +> If the page is completly empty then ikiwiki is crashing before it can +> output anything, though this seems unlikely. Check the webserver logs. + Now I see it created directories for my data. I fixed that by setting usedirs (I see that is in the release notes for 2.0) and rerunning ikiwiki --setup but I still have empty pages for editing (no textbox no html at all). @@ -62,6 +75,9 @@ but I still have empty pages for editing (no textbox no html at all). Is there any webpage with upgrade steps? +> Users are expected to read [[news]], which points out any incompatible +> changes or cases where manual action is needed. + --JeremyReed My followup: I used a new ikiwiki.setup based on the latest version. But no changes for me. @@ -71,12 +87,18 @@ rcs_recentchanges in my rcs perl module. The do=prefs does nothing though -- just a blank webpage. +> You need to figure out why ikiwiki is crashing. The webserver logs should +> tell you. + I also set verbose => 1 and running ikiwiki --setup was verbose, but no changes in running CGI. I was hoping for some output. I am guessing that my rcs perl module stopped working on the upgrade. I didn't notice any release notes on changes to revision control modules. Has something changed? I will also look. +> No, the rcs interface has not needed to change in a long time. Also, +> nothing is done with the rcs for do=prefs. + --JeremyReed ---- |